GE Dash 3000 Operator's Manual

Introduction
2000966-386D Dash™ 3000/4000/5000 1-15
Equipment Compliance Information
EN 60601-1 Component Classification
The number in the symbol indicates the EFUP period in years, as explained below. Check
the symbol on your equipment for its EFUP period.
This symbol indicates the product contains hazardous materials in excess of the limits
established by the Chinese standard SJ/T11363-2006 Requirements for Concentration
Limits for Certain Hazardous Substances in Electronic Information Products. The number in
the symbol is the Environment-friendly User Period (EFUP), which indicates the period
during which the toxic or hazardous substances or elements contained in electronic
information products will not leak or mutate under normal operating conditions so that the
use of such electronic information products will not result in any severe environmental
pollution, any bodily injury or damage to any assets. The unit of the period is “Year”.
In order to maintain the declared EFUP, the product shall be operated normally according to
the instructions and environmental conditions as defined in the product manual, and
periodic maintenance schedules specified in Product Maintenance Procedures shall be
followed strictly.
Consumables or certain parts may have their own label with an EFUP value less than the
product. Periodic replacement of those consumables or parts to maintain the declared
EFUP shall be done in accordance with the Product Maintenance Procedures. This product
must not be disposed of as unsorted municipal waste, and must be collected separately
and handled properly after decommissioning.
This symbol indicates that this electronic information product does not contain any toxic or
hazardous substance or elements above the maximum concentration value established by
the Chinese standard SJ/T11363-2006, and can be recycled after being discarded, and
should not be casually discarded.
Type of
protection
against
electrical
shock
1
Degree of protection against
electrical shock
2
Degree of
protection
against
harmful
ingress of
water
3
Degree of
safety of
application in
the presence of
a flammable
anesthetic
mixture with air
or with oxygen
or nitrous
oxide
4
Method of
sterilization/
disinfection
recommended
by the
manufacturer
Mode of
Operation
Monitor
I
BF (NBP, SpO
2
, CO
2
)
CF (ECG, Resp, IP, Temp/CO)
Ordinary Not Suitable N/A Continuous
ICG Module
N/A
BF
SAM Module B
PRN-50 Writer I
Not Marked
Remote Control N/A
TRAM-RAC 2A
(powered)
I

GE Dash 3000 Specifications

General

Brand	GE
Model	Dash 3000
Category	Monitor
Language	English