GE MEDICAL SYSTEMS
D
IRECTION FK091075, REVISION 04 VIVID 3N PRO/EXPERT SERVICE MANUAL
8-126 Section 8-8 - Peripherals
8-8-3 JVC VCR Replacement Procedure
NOTE: This section describes the installation and removal procedure of the JVC Video Casette Recorder.
The SR-S388E (PAL) and SR-S365U (NTSC) models are alike, except for the Color Signal system.
The installation procedure is the same for both models.
Note: When installing the JVC VCR, use the cables supplied with the VCR and not those supplied
with the Vivid 3 system.
8-8-3-1 Tools
No special tools needed.
8-8-3-2 Manpower
One person - 30 mins.
8-8-3-3 Preparations
1) Shut down the Vivid 3N Pro/Expert ultrasound unit, as described in Chapter 3 - Installation.
2.) Remove the Connectors Panel cover as shown in 8-2-5-3 "Connector Panels Cover Removal
Procedure" on page 8-8.
3.) Unpack the VCR and place it on a table (or firm surface).
4.) Check that the VCR AC voltage corresponds to that of your local voltage.
5.) Proceed to the JVC VCR Setup Procedures on the next page.
Figure 8-109 JVC Video Cassette Recorder (VCR)
To Next Page
Loading...
Need help?
General
