GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 13
8-4-9 Reloading the Software from Repository
8-4-9-1 Introduction to Software Reload from Repository
During the installation process, when the software was installed on the VIVID E9, the compressed
original files, from the DVD and CD, were stored on a separate disk partition on the hard disk drive,
labeled “REPOSIT” (Repository). If you are going to reinstall the software, you can install from these
files. Usually, when reinstalling the software on the same HDD, you don’t need to copy the files from
DVD/CD once more!
8-4-9-2 Preparations
Disconnect all external USB devices before starting the reload. (This is to ensure that the drive letters
are not mixed up during the software reload.)
To Next Page
Loading...
Need help?
General
