GE Vivid E9 Service Manual

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
8 - 314 Section 8-14 - Peripherals replacement
8-14-5 Color Video Printer Replacement
8-14-5-1 Preparations
• Power down the VIVID E9.
8-14-5-2 Color Video Printer removal
• If you are going to move the VIVID E9 to another location:
1.) Switch off the power on the printer.
2.) Disconnect the USB cable from the VIVID E9.
• If you are going to replace the printer:
1.) Switch off the power on the printer.
2.) Disconnect the USB cable from the printer.
3.) Remove the printer.
8-14-5-3 Color Video Printer installation
Preparation
• MITSUBISHI color printer CP30DW:
- Set Switch 1 and 2 on the rear side of the printer to ON.
Please refer to the documentation for the printer if you need help to locate the switches.
• If you are installing a new printer model, please refer to the Printer Driver Installation Manual,
Direction Number GA294652 revision 3 or higher, for installation and setup instructions.
General installation instructions
1.) Connect the USB cable to the printer and to the USB port on VIVID E9’s Rear Panel.
2.) Connect the power cable to the printer and to the mains power outlet.
3.) Switch on the power on the printer.
WARNINGWARNING
ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.
WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO
VOLTAGE GREATER THAN 30 VOLTS:
1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.
2. TURN OFF THE BREAKER.
3. UNPLUG THE VIVID E9.
4. MAINTAIN CONTROL OF THE POWER PLUG.
5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO
VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.
BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER
IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.
Signed
Date
TA G
&
LOCKOUT

GE Vivid E9 Specifications

General

Brand	GE
Model	Vivid E9
Category	Medical Equipment
Language	English