GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 284 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-10 Video Jumper (Flex) replacement
The Video Jumper (Flex) is used in VIVID E9 with 2D and without DVR.
The jumper is included in the BEP6.X Cable Kit - Spare Part, Part Number 5433408-80.
8-11-10-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.)
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
8-11-10-2 Video Jumper (Flex) removal
Follow these steps to remove the Video Jumper (Flex):
1.) Flip the retainer levers on the side of the connectors CN DV11 and CN DV12 to the side.
2.) Unplug and remove the Video Jumper (Flex).
8-11-10-3 Video Jumper (Flex) installation
Follow these steps to install the Video Jumper (Flex):
1.) Connect the two connectors on the Video Jumper (Flex) to CN DV11 and CN DV12 (on the BEP’s
motherboard).
2.) Install the BEP Cover.
3.) Install the Left Side Cover.
To Next Page
Loading...
Need help?
General
