GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 285
8-11-11 DVI to Samtec Jumper (Flex) replacement
The DVI to Samtec Jumper (Flex) is included in the BEP6.X Cable Kit - Spare Part,
Part Number 5433408-80.
8-11-11-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.)
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
8-11-11-2 DVI to Samtec Jumper (Flex) removal
The number of cables in use, depends on the configuration:
• 4D with DVR: one cable is used.
• 4D without DVR: one cable is used.
• 2D with DVR: two cables are used.
• 2D without DVR does not use this cable.
Follow these steps to remove the DVI to Samtec Jumper (Flex):
1.) Disconnect the cable from CN DV12 (on the motherboard).
2.) Repeat the step above for the second cable, if installed.
To Next Page
Loading...
Need help?
General
