GE Vivid E9 Service Manual

GE H EALTHCARE
D IRECTION GA091568, R EVISION 5 VIVID E9 S ERVICE M ANUAL
Chapter 8 - Replacement procedures 8 - 45
8-5-5 Foot Rest Bumper replacement
8-5-5-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
8-5-5-2 Foot Rest Bumper removal
Follow these steps to remove the Foot Rest Bumper:
The Foot Rest Bumper is fixed with snap locks.
1.) Pull the Foot Rest Bumper upwards and over the pedals to release the snap locks, while freeing the
side latches.
You may need to push down the pedals to be able to remove the Foot Rest Bumper.
NOTE: In the illustration below (Figure 8-51), the Side Cover was removed to be able to view the Side
Latch. You don’t need to remove the Side Cover to perform this procedure.
8-5-5-3 Foot Rest Bumper installation
Follow these steps to install the Foot Rest Bumper:
1.) Position the Foot Rest Bumper in place.
WARNINGWARNING
ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.
WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO
VOLTAGE GREATER THAN 30 VOLTS:
1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.
2. TURN OFF THE BREAKER.
3. UNPLUG THE VIVID E9.
4. MAINTAIN CONTROL OF THE POWER PLUG.
5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO
VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.
BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER
IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.
Figure 8-51 Side latch
Signed
Date
TA G
&
LOCKOUT

GE Vivid E9 Specifications

General

Brand	GE
Model	Vivid E9
Category	Medical Equipment
Language	English