Gendex GXDP-700 User Manual

1 Introduction
2 Gendex Dental Systems
207723 rev 7
1.2 Intended use
The unit is intended for dental radiographic examination of
teeth, jaw and TMJ areas by producing conventional 2D x-
ray images as well as x-ray projection images of an
examined volume for the reconstruction of a 3D view.
The unit is also intended for carpus imaging in assisting
cephalometric analyses (Not in USA).
CAUTION! USA only: Federal law restricts this device to
sale by or on the order of a dentist or other qualified
professional.
1.3 Intended user profile
Only for professionally qualified dental / medical personnel.
Typical user is a dental assistant with specific training for
using dental x-ray units.
1.4 Associated documentation
• GXDP-700 user manual
• GXDP-700 installation manual
• GxPicture Driver software installation manual
• The user manual supplied with the dental imaging
software (e.g. VixWin)
• The installation manual supplied with the dental
imaging software (e.g. VixWin)
• The user manual supplied with the 3D imaging
software (e.g. InVivo)
• The installation manual supplied with the 3D
imaging software (e.g. InVivo)
1.5 References
The following instructions are delivered with in the
GXDP-700 installation manual:
• Firmware update instructions
• Calibration instructions
• Cephalostat upgrade instructions
• Cephalostat side changing instructions
Approved: Laihonen Tuuli 2016-12-02 16:41
Reviewed: Nieminen Timo Antero 2016-12-02 15:31
Approved
See PDM system to determine the status of this document. Printed out: 2017-03-22 10:54:38
D507729, 7
Copyright © 2016 by PaloDEx Group Oy. All rights reserved.

Gendex GXDP-700 Specifications

General

Brand	Gendex
Model	GXDP-700
Category	Dental equipment
Language	English