MAINTENCE AND ADJUSTMENT OF THE UTV
- 98 -
NOTE:
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check, and if
necessary, correct the antifreeze concentration
of the coolant. Use only distilled water.
However, soft water may be used if distilled
water is not available.
14. Install:
·air bleed bolt
9 Nm (0.9 m · kg, 6.5 ft · lb)
·radiator cap；
·Fill coolant reservoir；
·Install coolant reservoir cap:
·Start the engine, warm it up for several minutes,
and then turn it off.
·Check:
coolant level
Refer to “THE COOLANT” in chapter 4.
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
·Close the hood.
·Install driver seat
Refer to “SEATS,” in chapter 5.
CHECKING THE COOLANT TEMPERATURE
WARNING LIGHT
Coolant temperature indicator light ①
.
To Next Page
Loading...
Need help?
General
