EasyManuals Logo

Hisun Motors HS800UTV 2014 User Manual

Hisun Motors HS800UTV 2014
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
GENERAL INFORMATION
- 33 -
Result: Ensure the engine can work with steady idle speed and conducive to complete the engine
warm-up process quickly after start engine in low temperature.
2.Special fault:
Idle instability, CH and CO of off-gas out of limits
Reason:Oxygen sensor loosing cause slight leakage or pipe slight leakage and makes the
oxygen sensor collect too much oxygen ion signal. The wrong signal transmits to the ECU which
result the increasing of oil supply. Finally, it causes the oil too thick.
3.Special fault:
In the vehicle driving process, there is no idle speed or too low idle speed when restart it after
storage battery power off abnormally.
Countermeasure: Step on the throttle slightly when start the engine and maintain for a few
seconds. And then let go of the throttle, remove the key and switch off the vehicle. After waiting for
ten minutes, switch on with the key that could restart the engine.
4.Special fault:
Abnormal high temperature of muffler burn down covering parts or cause the rupture of muffler
or exhaust pipe
Reason:800UTV adopts two-cylinder engine with two oxygen sensors. If the two oxygen sensors
disturb each other, the EFI system will appear mistake which results high temperature error.
Countermeasure: If it is found that the temperature of muffler is too high, please check whether
the plug of oxygen sensor is in wrong position.
5.Special fault:
The engine can’t start normally after changing air filter or air throttle
Reason
:
The inner cleanness of old air filter and air throttle is poor after long running. The idle
speed step motor will revise the volume of air up automatically. If change to new air filter or air
throttle, idle speed step motor inside ECU need to match the volume of oil when in idle speed
automatically.
Countermeasure: When start the engine, run 2 to 3 minutes in idle speed. If it can’t run normally
in idle, turn off the engine and restart it repeatedly 10 seconds later until it can run normally in idle.
Or switch on and off the key 5 times in a row which can reset all saved data in ECU.
Engine is cold
1. Shift the transmission into neutral.
2. Turn the fuel valve on or confirm if the fuel is in upper or below retile in the fuel tank.
3. Start the engine and run in neutral for 1 minute to enhance the temperature of engine. If it runs
normally in neutral, you can drive the UTV.
NOTE
Race the engine with high power in low
temperature will cause damage to the engine.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hisun Motors HS800UTV 2014 and is the answer not in the manual?

Hisun Motors HS800UTV 2014 Specifications

General IconGeneral
BrandHisun Motors
ModelHS800UTV 2014
CategoryUtility Vehicle
LanguageEnglish

Related product manuals