MAINTENCE AND ADJUSTMENT OF THE UTV
- 110 -
□
R
Rear
CHECKING THE STEERING SYSTEM
1. place the vehicle on the flat ground .
● Check:
Clamp seat of steeing vertical column and sliding
bearing on the lower end of steering vertical column,
upper ＆ lower and front ＆ rear moving steering
bar .If the cleearance is too large, replace the
sliding bearing.
Refer to secrtion “Steering ststem” of chapter 5.
● Check:
tie-rod ends
Ball pin unit of steering tension rod.
Rotate the steering bar leftward and / or rightward,
Then roate from left to right lightly . If the ball pin
unit of steering tension rod have any vertical
clearance , replace it .
Refer to secrtion “Steering ststem” of chapter 5.
● Check:
Ball joints and/or wheel bearings Move the wheels
laterally back and forth. Excessive free
play
Replace the front arms (upper and lower)
and/or wheel bearings.
.
To Next Page
Loading...
Need help?
General
