HP A5120 EI Series User Manual

138
Description
Use the display ipv6 interface command to display the IPv6 information of an interface.
If interface-type interface-number is not specified, the IPv6 information of all interfaces is displayed; if
only interface-type is specified, the IPv6 information of the interfaces of the specified type is displayed; if
interface-type interface-number is specified, the IPv6 information of the specified interface is displayed. If
the verbose keyword is also specified, the detailed IPv6 information of the interface is displayed.
Examples
# Display the IPv6 information of VLAN-interface 2.
<Sysname> display ipv6 interface vlan-interface 2 verbose
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::1234:56FF:FE65:4322
Global unicast address(es):
2001::1, subnet is 2001::/64
10::1234:56FF:FE65:4322, subnet is 10::/64 [AUTOCFG]
[valid lifetime 4641s/preferred lifetime 4637s]
Joined group address(es):
FF02::1:FF00:1
FF02::1:FF65:4322
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 0
InTooShorts: 0
InTruncatedPkts: 0
InHopLimitExceeds: 0
InBadHeaders: 0
InBadOptions: 0
ReasmReqds: 0
ReasmOKs: 0
InFragDrops: 0
InFragTimeouts: 0
OutFragFails: 0
InUnknownProtos: 0
InDelivers: 0
OutRequests: 0
OutForwDatagrams: 0
InNoRoutes: 0
InTooBigErrors: 0
OutFragOKs: 0
OutFragCreates: 0
InMcastPkts: 0

HP A5120 EI Series Specifications

General

Brand	HP
Model	A5120 EI Series
Category	Switch
Language	English