162
ipv6 icmp-error
Syntax
ipv6 icmp-error { bucket bucket-size | ratelimit interval } *
undo ipv6 icmp-error
View
System view
Default level
2: System level
Parameters
bucket bucket-size: Specifies the number of tokens in the token bucket, in the range 1 to 200.
ratelimit interval: Specifies the update period of the token bucket in milliseconds, in the range 0 to
2,147,483,647. The update period ―0‖ indicates that the number of ICMPv6 error packets sent is not
restricted.
Description
Use the ipv6 icmp-error command to configure the size and update period of the token bucket.
Use the undo ipv6 icmp-error command to restore the defaults.
By default, the size is 10 and the update period is 100 milliseconds. Up to 10 ICMPv6 error packets can
be sent within 100 milliseconds.
Examples
# Set the capacity of the token bucket to 50 and the update period to 100 milliseconds.
<Sysname> system-view
[Sysname] ipv6 icmp-error bucket 50 ratelimit 100
ipv6 icmpv6 multicast-echo-reply enable
Syntax
ipv6 icmpv6 multicast-echo-reply enable
undo ipv6 icmpv6 multicast-echo-reply
View
System view
Default level
2: System level
Parameters
None
Description
Use the ipv6 icmpv6 multicast-echo-reply enable command to enable replying to multicast echo requests.
Use the undo ipv6 icmpv6 multicast-echo-reply command to disable replying to multicast echo requests.
By default, the switch is disabled from replying to multicast echo requests.
To Next Page
Loading...
Need help?
General