166
Examples
# Specify VLAN-interface 100 to retransmit NS messages at intervals of 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ns retrans-timer 10000
ipv6 nd nud reachable-time
Syntax
ipv6 nd nud reachable-time value
undo ipv6 nd nud reachable-time
View
Interface view
Default level
2: System level
Parameters
value: Specifies the neighbor reachable time in milliseconds, in the range 1 to 3,600,000.
Description
Use the ipv6 nd nud reachable-time command to configure the neighbor reachable time on an interface.
This time value serves as not only the neighbor reachable time on the local interface, but also the value of
the Reachable Time field in RA messages sent by the local interface.
Use the undo ipv6 nd nud reachable-time command to restore the default.
By default, the neighbor reachable time on the local interface is 30,000 milliseconds and the value of the
Reachable Time field in RA messages is 0, so that the reachable time is determined by the receiving
device.
Related commands: display ipv6 interface.
Examples
# Set the neighbor reachable time on VLAN-interface 100 to 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd nud reachable-time 10000
ipv6 nd proxy enable
Syntax
ipv6 nd proxy enable
undo ipv6 nd proxy enable
View
VLAN interface view
Default level
2: System level
To Next Page
Loading...
Need help?
General