7
Parameters
None
Description
Use the mac-address station-move quick-notify enable command to enable ARP quick update.
Use the undo mac-address station-move quick-notify enable command to restore the default.
By default, ARP quick update is disabled.
Example
# Enable ARP quick update.
<Sysname> system-view
[Sysname] mac-address station-move quick-notify enable
reset arp
Syntax
reset arp { all | dynamic | static | slot slot-number | interface interface-type interface-number }
View
User view
Default level
2: System level
Parameters
all: Clears all ARP entries.
dynamic: Clears all dynamic ARP entries.
static: Clears all static ARP entries.
slot slot-number: Clears the ARP entries for the specified device. The slot-number argument is the member
number of the device in the IRF, which you can display with the display irf command. The value range for
the slot-number argument depends on the number of members and numbering conditions in the current
IRF. If no IRF exists, the slot-number argument is the current device number.
If the switch does not support IRF, the slot-number argument must be 1.
interface interface-type interface-number: Clears the ARP entries for the interface specified by the
argument interface-type interface-number.
Description
Use the reset arp command to clear ARP entries from the ARP mapping table.
Related commands: arp static and display arp.
Examples
# Clear all static ARP entries.
<Sysname> reset arp static
To Next Page
Loading...
Need help?
General