163
Examples
# Enable replying to multicast echo requests.
<Sysname> system-view
[Sysname] ipv6 icmpv6 multicast-echo-reply enable
ipv6 nd autoconfig managed-address-flag
Syntax
ipv6 nd autoconfig managed-address-flag
undo ipv6 nd autoconfig managed-address-flag
View
Interface view
Default level
2: System level
Parameters
None
Description
Use the ipv6 nd autoconfig managed-address-flag command to set the managed address configuration
(M) flag to 1 so that the host can acquire an IPv6 address through stateful autoconfiguration (for example,
from a DHCP server).
Use the undo ipv6 nd autoconfig managed-address-flag command to restore the default.
By default, the M flag is set to 0 so that the host can acquire an IPv6 address through stateless
autoconfiguration.
Examples
# Configure the host to acquire an IPv6 address through stateful autoconfiguration.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd autoconfig managed-address-flag
ipv6 nd autoconfig other-flag
Syntax
ipv6 nd autoconfig other-flag
undo ipv6 nd autoconfig other-flag
View
Interface view
Default level
2: System level
Parameters
None
To Next Page
Loading...
Need help?
General