194
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] ipv6 dhcp server apply pool 1 allow-hint preference 255 rapid-
commit
ipv6 dhcp server enable
Syntax
ipv6 dhcp server enable
undo ipv6 dhcp server enable
View
System view
Default level
2: System level
Parameters
None
Description
Use the ipv6 dhcp server enable command to enable the DHCPv6 server.
Use the undo ipv6 dhcp server enable command to disable the DHCPv6 server.
By default, the DHCPv6 server is disabled.
Other DHCPv6 server related configuration is effective only when the DHCPv6 server is enabled.
Examples
# Enable the DHCPv6 server.
<Sysname> system-view
[Sysname] ipv6 dhcp server enable
prefix-pool
Syntax
prefix-pool prefix-pool-number [ preferred-lifetime preferred-lifetime valid-lifetime valid-lifetime ]
undo prefix-pool
View
DHCPv6 address pool view
Default level
2: System level
Parameters
prefix-pool-number: Specifies the prefix pool number. The value ranges from 1 to 128..
preferred-lifetime preferred-lifetime: Specifies the preferred lifetime of prefixes to be assigned. The value
ranges from 60 to 4,294,967,295, in seconds. The default value is 604,800 seconds, that is, seven days.
To Next Page
Loading...
Need help?
General