174
View
System view
Default level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address.
value: Specifies the PMTU of a specified IPv6 address in bytes, in the range 1280 to 10,000.
Description
Use the ipv6 pathmtu command to configure a static PMTU for a specified IPv6 address.
Use the undo ipv6 pathmtu command to remove the PMTU configuration for a specified IPv6 address.
By default, no static PMTU is configured.
Examples
# Configure a static PMTU for a specified IPv6 address.
<Sysname> system-view
[Sysname] ipv6 pathmtu fe80::12 1300
ipv6 pathmtu age
Syntax
ipv6 pathmtu age age-time
undo ipv6 pathmtu age
View
System view
Default level
2: System level
Parameters
age-time: Specifies the aging time for PMTU in minutes, in the range 10 to 100.
Description
Use the ipv6 pathmtu age command to configure the aging time for a dynamic PMTU.
Use the undo ipv6 pathmtu age command to restore the default.
By default, the aging time is 10 minutes.
The aging time is invalid for a static PMTU.
Related commands: display ipv6 pathmtu.
Examples
# Set the aging time for a dynamic PMTU to 40 minutes.
<Sysname> system-view
[Sysname] ipv6 pathmtu age 40
To Next Page
Loading...
Need help?
General