83
dhcp-snooping information remote-id format-type
Syntax
dhcp-snooping information remote-id format-type { ascii | hex }
undo dhcp-snooping information remote-id format-type
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
ascii: Specifies the code type for the remote ID sub-option as ascii.
hex: Specifies the code type for the remote ID sub-option as hex.
Description
Use the dhcp-snooping information remote-id format-type command to configure the code type for the
non-user-defined remote ID sub-option.
Use the undo dhcp-snooping information remote-id format-type command to restore the default.
By default, the code type for the remote ID sub-option is HEX.
This command applies only to configuring a non-user-defined remote ID sub-option only. After you
configure the padding content for the remote ID sub-option using the dhcp-snooping information remote-
id string command, ASCII is adopted as the code type.
Related commands: display dhcp-snooping information.
Examples
# Configure the code type for the non-user-defined remote ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dhcp-snooping information remote-id format-type ascii
dhcp-snooping information remote-id string
Syntax
dhcp-snooping information [ vlan vlan-id ] remote-id string { remote-id | sysname }
undo dhcp-snooping information [ vlan vlan-id ] remote-id string
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN ID, in the range 1 to 4094.
To Next Page
Loading...
Need help?
General