Table 5-26 iLO 2 MP Status LEDs
LED StateiLO 2 MP Status LED
Flashing greeniLO 2 MP heartbeat
Off: The LED is solid amber when ac power is applied. It
remains solid amber for a few seconds until the iLO 2 MP
completes its self-test; then the LED turns off
iLO 2 MP self-test
Flashing greenBMC heartbeat
Solid greenStandby power
Manageability Reset Button on System Board Bulkhead
The Manageability reset button, accessed from the rear of the server, allows you to reset the iLO
2 MP, it optionally also resets user-specified values to factory default values. A momentary press
causes a soft reset of the iLO 2 MP, when the button is released. A greater than four-second press
does the same, and also returns user-specified values to factory default values (hard reset).
The crucial values to be reset are as follows:
• Serial terminal baud settings
• User names and passwords
Manageability Status LED
The manageability status LED indicates the state and health of the iLO 2 MP. It is visible from
the rear of the server. The states are as follows:
Table 5-27 Manageability Status LED
DefinitionLED State
iLO 2 MP is not respondingOff
Self TestSteady Amber
Heartbeat0.5 Hz Flashing Green
ROM Error1 Hz Flashing Amber
I/O Subsystem (SAS/DVD/HDD)
Verifying SAS Disk Drive Operation
Each SAS disk drive has an activity LED indicator on the front of the drive.
NOTE: On the HP Integrity rx2660 server, only the activity LED is used. The status LED is not
monitored by the OS.
Verify that the LED shows the correct activity indication for all disk drives that you installed:
1. Turn on power to the server and display monitor.
134 Troubleshooting
To Next Page
Loading...
Need help?
General