Figure 6-18 Removing the System Insight Display from the Front Bezel
Replacing the System Insight Display
To replace the System Insight Display, follow these steps:
1. Insert the System Insight Display into the opening in the front bezel and push the board
toward the rear of the server until it snaps into place.
2. NOTE: The System Insight Display is keyed to fit into the bezel in only one direction.
3. Replace the front bezel on the front of the server. See “Replacing the Front Bezel” (page 159).
4. Reconnect the System Insight Display power cable to the fan/display board.
5. Replace the front fan carrier assembly. See “Replacing the Fan Carrier Assembly” (page 163).
6. Replace the fans into the fan carrier. See “Replacing a Server Fan ” (page 152).
7. Replace the top cover. See “Replacing the Top Cover” (page 144).
8. Reconnect the power cables and power on the server. See “Powering On and Powering Off
the Server” (page 78).
9. Respond YES to prompts regarding copying information onto the new board.
160 Removing and Replacing Server Components
To Next Page
Loading...
Need help?
General