2 Server Specifications
This chapter provides the specifications for the HP Integrity rx2660 server.
This chapter addresses the following topics:
• “System Configuration” (page 36).
• “Dimensions and Weight” (page 37)
• “Grounding” (page 37).
• “Electrical Specifications” (page 37).
• “Physical and Environmental Specifications” (page 38)
For information on general computer room site preparation, see the HP Generalized Site Preparation
Guide on the HP website at www.docs.hp.com.
System Configuration
Table 2-1 lists the hardware specifications for the HP Integrity rx2660 server.
Table 2-1 Hardware Specifications
HP Integrity rx2660Component
One or two Itanium single- or dual-core processors:Processors
• 1.6 GHz/6 MB cache single-core processor
• 1.4 GHz/12 MB cache dual-core processor
• 1.6 GHz/18 MB cache dual-core processor
• 1.6 GHz/12 MB cache single-core processor
• 1.42 GHz/12 MB cache dual-core processor
• 1.67 GHz/18 MB cache dual-core processor
Supports up to eight Double Data Rate 2 (DDR2) DIMMs mounted on the system board.Memory
Supported DIMM sizes are as follows:
• 512 MB
• 1 GB
• 2 GB
• 4 GB
Minimum memory configuration is 1 GB (2 x 512 MB DIMMs).
Maximum memory configuration is 32 GB (8 x 4 GB DIMMs).
One to eight hot-pluggable SAS hard drives.Disk drives
For the PCI-X I/O backplane assembly:PCI slots
• One PCI-X slot @ 133 MHz
• Two PCI-X slots @ 266 MHz
For the PCIe/PCI-X I/O backplane assembly:
• One PCI-X slot @ 133 MHz
• Two PCIe slots @ PCIe x8
Eight port SAS core I/O card, or eight port SAS core I/O card with RAID expansion card.SAS core I/O
Two GigE LAN ports.LAN core I/O
Two serial ports, two USB 2.0 ports, one 10 Base-T/100 Base-T LAN port, and one optional
VGA port.
Management core I/O
One DVD-R or DVD+RW.Optical device
The Data Center server has one 900 watt (@120 VAC) or 1000 watt (@240 VAC) power supply,
1+1 redundancy with second power supply.
The Office Friendly configuration includes two power supplies.
Power supply
36 Server Specifications