Network configuration
IP QoS
5-18
Example
This example shows how to create two IP QoS profiles and associated them with a VSC. The
two profiles are:
Voice: Provides voice traffic with high priority.
Web: Provides HTTP traffic with low priority.
Create the profiles
1. Select Network > IP QoS, and then Add New Profile. The Add/Edit IP QoS Profile
page opens.
2. For Profile name, specify Voice.
3. Set Protocol to TCP.
4. Set Start port to SIP. Start port and End port are automatically populated with the
correct value: 5060.
5. Set Priority to Very High.
6. Select Save.
Note You could also create another profile using the same parameters but with Protocol set to
UDP in order to handle any kind of SIP traffic.
7. On the IP QoS Profile page select Add New Profile.
8. Set Profile name to Web.
9. Set Protocol to TCP.
10. Set Start port to http. Start port and End port are automatically populated with the
common HTTP port: 80.
To Next Page
Loading...
Need help?
General
