The password must meet the following requirements:
● Contain 8 to 20 characters.
● Contain at least one space or one of the following special characters:
`~!@#$%^&*()-_=+\|[{}];:'",<.>/?
● Contain at least two types of the following characters:
Lowercase letters a to z
Uppercase letters A to Z
Digits 0 to 9
● Cannot be the same as the user name or the user name in reverse order.
● Contain at least two new characters when compared with the old password.
Step 7 Click Save.
The initial password of the iBMC is changed.
----End
7.4.3.2 Changing the Initial U-Boot Password
● U-Boot is a kind of underlying software used to congure basic settings, for example,
initialize hardware devices and set up memory space mapping, to prepare for
commissioning the OS.
● For security purposes, change the initial password upon the
rst login and periodically
change the password.
● You are advised to use a password that meets complexity requirements or to enable the
password complexity check function.
● The password complexity check function is enabled by default.
Procedure
Step 1 Log in to the iBMC CLI.
For details, see 9.4 Logging In to the CLI.
Step 2 Restart the iBMC.
ipmcset -d reset
The command output is as follows:
This operation will reboot IPMC system. Continue? [Y/N]:
Step 3 Enter y.
The system restarts.
Step 4 Press Ctrl+B immediately when the following information is displayed:
Hit 'ctrl + b' to stop autoboot: 1
Step 5 Enter the default password (Admin@9000).
The U-Boot interface is displayed.
u-boot>
FusionServer Pro 2288X V5 Server
User Guide 7 Installation and Conguration
Issue 04 (2020-06-05) Copyright © Huawei Technologies Co., Ltd. 101
To Next Page
Loading...
Need help?
General