Step 4 Lower the ejector lever until the hard disk enclosure clips to the beam of the front
I/O module and the hard disk is fully installed to the front I/O module. See step
(2) in Figure 5-67.
Step 5 Push the hard disk enclosure into the front I/O module. See step (1) in Figure
5-68.
Figure 5-68 Pushing a hard disk enclosure
Step 6 Lower the ejector lever of the hard disk enclosure. See step (2) in Figure 5-68.
----End
5.6.5 Removing a RAID Controller Card
This topic describes how to remove a RAID controller card.
Scenarios
Remove a RAID controller card if:
● The RAID controller card has failed.
● The RAID controller card needs to be replaced with a new model.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 186
To Next Page
Loading...
Need help?
General