Figure 5-46 Power cable connections
----End
5.5.9 Removing a RAID Controller Card
This topic describes how to remove a RAID controller card.
Scenarios
Remove a RAID controller card if:
● The RAID controller card has failed.
● The RAID controller card needs to be replaced with a new model.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the front I/O module from the RH8100 V3. For details, see
5.5.1 Removing the Front I/O Module.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a RAID
controller card.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 164
To Next Page
Loading...
Need help?
General