● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing the front
I/O module.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Raise both ejector levers on the front I/O module. See step (1) in Figure 5-107.
Step 3 Pull the front I/O module out of the slot while holding the ejector levers. See step
(2) in Figure 5-107.
Figure 5-107 Removing a front I/O module
Step 4 Remove the RAID controller cards, supercapacitor, and hard disk backplane from
the front I/O module, and place the front I/O module in an ESD bag.
For details, see 5.8.7 Removing a RAID Controller Card, 5.8.9 Removing a
Supercapacitor, and 5.8.11 Removing a Hard Disk Backplane.
----End
5.8.2 Installing a Front I/O Module
This topic describes how to install a front I/O module.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 226
To Next Page
Loading...
Need help?
General