● The rear I/O module has failed.
● A non-hot-swappable PCIe card on the rear I/O module has failed.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have installed all non-hot-swappable PCIe cards on the rear I/O module
to be installed. For details, see 5.11.6 Installing a Non-Hot-Swappable PCIe
Card.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for installing a rear I/O
module.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
Hardware
Spare rear I/O module
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Take the spare rear I/O module out of the ESD bag, and install all non-hot-
swappable PCIe cards of the required model on the rear I/O module.
Step 3 Insert the rear I/O module into the slot. See step (1) in Figure 5-150.
Step 4 Lower the ejector levers on the rear I/O module. See step (2) in Figure 5-150.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 281
To Next Page
Loading...
Need help?
General