Hypertherm SYNC Powermax 65 User Manual

Powermax65/85/105 SYNC Operator Manual 810470 63
Operate the Plasma System
Make sure that the plasma power supply is connected to gas and power
1. Connect the gas supply line to the fitting on the back of the plasma power supply. Refer to
page 54.
 For gas supply requirements, refer to Gas supply source on page 55.
2. Make sure that the plasma power supply’s power cord is correctly connected to electrical power
according to national and local codes. Refer to Connect to electrical power on page 40, and
Prepare the power cord and plug on page 45.

Hypertherm SYNC Powermax 65 Specifications

General

Brand	Hypertherm
Model	SYNC Powermax 65
Category	Welding System
Language	English