Hypertherm SYNC Powermax 65 User Manual

Cut with the Hand Torch
4
Powermax65/85/105 SYNC Operator Manual 810470 103
Use a FlushCut specialty cartridge
FlushCut cartridges can remove lugs, bolts, pad eyes, and other attachments without piercing or
damaging the workpiece below. You can also use FlushCut cartridges for metal washing. You can
turn the tip of the FlushCut cartridge as necessary to get an angled plasma arc that lets you cut very
close to the base material without leaving a large amount of remaining material to grind off.
FlushCut cartridgeStandard cartridge
WARNING
ARC RAYS CAN BURN EYES AND SKIN
When you use FlushCut cartridges, wear a face shield that covers your entire face. Use a
shield with a shade 10 lens.
Plasma arc rays produce intense visible and invisible (ultraviolet and infrared) rays that can
burn eyes and skin.
WARNING
INSTANT-ON TORCHES – PLASMA ARC CAN CAUSE INJURY, BURNS
Ignition of the plasma arc occurs immediately when you pull the torch trigger. Before
changing the cartridge, one of the following steps is necessary. Whenever possible,
complete the first step.
 Set the power switch on the plasma power supply to OFF (O).
OR
 Move the torch-lock switch to the yellow lock (X) position. Pull the trigger to make
sure that the torch does not fire a plasma arc.

Hypertherm SYNC Powermax 65 Specifications

General

Brand	Hypertherm
Model	SYNC Powermax 65
Category	Welding System
Language	English