9
BIIS 1200 SYSTEM OPERATION
9-10
D Deleting the Incoming list
The receive call log can be deleted from the Incoming
list�
(Menu > Signaling/Call > Clear Incoming)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Clear
Incoming,” then
push [OK]�
Call Menu ►
Clear Incoming ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select “Voice” or
“Message/Status” to be deleted, then
push [OK]�
Voice ►
Message/Status ►
Clear Incoming
• Voice: The received Individual or
Group call entries are saved in
the entries�
• Message/Status: The received Status Message
and Message entries are
saved in the entries�
5� After a dialog is displayed as shown below, push
[P2 (Up)] or [P1 (Down)] to select <OK> on the
screen and push [OK]�
R Are u Sure?
Cancel
OK
• The selected call log is deleted from the Incoming list�
6�
Hold down [Back] for 1 second to return to the
standby screen�
Incoming list
To Next Page
Loading...
Need help?
General
