7
NXDN™ OPERATION
7-4
D Transmitting a Group call
You can call a specic group.
(Menu > Signaling/Call > Call List Select)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Call List
Select,” then
push [OK]�
Call List Select ►
Call Menu ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select the Group
ID�
✔ Station 1
✔ Group 1
Call List Select
5� Push [PTT] to transmit a Group call�
6� Hold down [PTT] to speak�
7� Release [PTT] to receive�
TIP:
• You can also select a Group in the “Group Select”
screen�
(Menu > Signaling/Call > Group Select)
• You can also transmit a Group call through the Call
Menu�
(Menu > Signaling/Call > Call menu)
• When a Group ID is set in the Memory CH, you
can transmit the Group call by pushing [PTT] on
the channel�
• Push [Call List Select] to directly display the “Call
List Select” screen in step 4 to the left�
Transmitting a call
To Next Page
Loading...
Need help?
General
