5
SCAN OPERATION
5-2
A Scan checks for signals on each channel and stops
when a signal is received�
NOTE: Two or more channels must be preset to start
a Scan�
(Menu > Channel/Scan > Scan ON/OFF)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Channel/
Scan,” then
push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “Scan ON/
OFF,” then
push [OK]�
Scan List ►
Scan ON/OFF ►
Channel/Scan
4� Push [Up] or [Down] to select “ON,” then push
[OK]�
✔ OFF
✔ ON
Scan ON/OFF
SCAN ON/OFF
ON
• The Scan starts�
• “Scan ON/OFF ON” is briey displayed.
L When a signal is detected, the Scan pauses on the
channel until the signal disappears, then the Scan
resumes�
5� Hold down [Back] for 1 second to return to the
standby screen�
• “ ” blinks while scanning� (Depending on the
transceiver version�)
Starting a Scan
To Next Page
Loading...
Need help?
General
