Icom IC-F52D User Manual

4
ADVANCED OPERATION
4-2
D Autodial
A user can quickly send DTMF tones that have been
pre-entered into the transceiver�
(Menu > Signaling/Call > DTMF Autodial)
1� Push [Menu] to display the Menu screen�
2� Push [P2 (Up)] or [P1 (Down)] to select “Signaling/
Call,” then push [OK]�
Channel/Scan ►
Signaling/Call ►
Menu
3� Push [P2 (Up)] or [P1 (Down)] to select “DTMF
Autodial,” then push [OK]�
DTMF Autodial ►
Group Select ►
Signaling/Call
4� Push [P2 (Up)] or [P1 (Down)] to select a DTMF
Memory, then push [PTT] to send the codes�
✔ DTMF 1
✔ DTMF 2
DTMF Autodial
• After sending, automatically returns to the standby
screen�
TIP: In the standby screen, a user can send the
currently selected DTMF Memory’s codes by holding
down [DTMF Autodial]� In the DTMF Autodial screen,
a check mark is displayed by the currently selected
codes�
D Stun function
(Only for LTR operation)
The Stun function is used when a transceiver is stolen
or lost, and the function deactivates the transceiver�
When the transceiver receives a matching Stun
DTMF code, the Stun function is activated and
the transceiver operation is inhibited� In this case,
entering the password or reprogramming is necessary
to operate the transceiver again�
DTMF calls

Icom IC-F52D Specifications

General

Brand	Icom
Model	IC-F52D
Category	Transceiver
Language	English