8
MDC 1200 SYSTEM OPERATION
8-9
D Receiving an MDC Stun, Kill, or
Revive call
If an MDC Stun or Kill call is received that matches
your station ID, the transceiver displays “Deactivated”
and you can not receive* or transmit�
Deactivated
To use the transceiver again, you need to:
• Receive* an MDC Revive call that matches your
station ID�
• Enter the password�
• Setup again using the CS-F52D programming
software�
* Depending on the presetting, reception may be enabled�
D Receiving an MDC Status call
When an MDC Status call is received�
• Beeps sound�
• The calling stationʼs ID and the Status message are
displayed once�
ID 1
Call Scan
Status 1
Call Scan
D Receiving an MDC Message call
When an MDC Message call is received�
• Beeps sound�
• The calling stationʼs ID and the Message are
alternately displayed�
MSG 1
Call Scan
ID 1
Call Scan
L To return to the Standby screen, push [PTT], or
change the channel�
Receiving a call
To Next Page
Loading...
Need help?
General
