Image Access Bookeye 4 User Manual

Operation Manual Page 37
A.13 Glass Plate Operating Modes
The Bookeye
®
4 scanner has two operation modes for the glass plate:
• Manual mode
• Automatic mode.
A.13.1 Setting the Operation Modes
The scanner starts with the operation mode which was set before it was powered-down.
To toggle between the modes, press and hold the Cradle Lock button (Picture 11) until
the Cradle Up and Cradle Down buttons blink.
Picture 12: Setting the book cradle mode
If both buttons blink in blue, the operation mode is set to automatic operation.
If both buttons blink in red, the operation mode is set to manual operation.
The current setting is also shown briefly (for approximately two seconds) on the
touchscreen. (see pictures below).
Picture 13: Manual operation Picture 14: Automatic operation
If the operation mode is set to automatic operation, the scan sequence starts
automatically when the glass plate is closed. In the setup level User a delay between
closing the glass plate and scan start can be defined.
It is recommended to set the operation mode to manual mode, before starting a scan job.

Image Access Bookeye 4 Specifications

General

Brand	Image Access
Model	Bookeye 4
Category	Scanner
Language	English