Operation Manual Page 5
About this Manual
Operation Manual
The Operation Manual provides all necessary information pertaining to the normal
operation and behavior of the device. It is written for people who only operate the device
and do not perform setup and adjustment procedures. All device elements and software
functions are described in detail, although some of them might never be used. This
manual does not cover any application software. Refer to the appropriate manual to learn
about the application software.
Setup Manual
The Setup Manual is written for technical staff with some basic mechanical skills and
software knowledge. Many resellers will offer on-site installation; therefore, large parts or
all of the setup and assembly manual may not be of interest to the reader. The access
level at which the setup and adjustment procedures are performed is called “Power user”.
This “Power user” level is password protected from access by the normal operator.
All manuals can be downloaded from our customer service portal at
portal.imageaccess.de
. Be sure to always check for the latest versions of these manuals.
This manual is divided into sections.
Section A describes the hardware of the device and gives an overview of all
components and connectors of the scanner. Remember that this device is a
precise optical instrument and should be handled accordingly.
Section B describes the functions of the touchscreen and how to operate the scanner
with the touchscreen.
Section C gives a short introduction and basic information about the new user
interface ScanWizard. All details about the interface can be found in the
integrated “Help” texts in the scanner.
Section D informs about the setup levels in general and describes the access level
User in detail.
Section E contains all technical information of the scanner and the manufacturer
declarations concerning safety and electromagnetic compatibility (EMC).
To Next Page
Loading...
Need help?
General
