Page 42 Operation Manual
A.14 The “Finger Removal” Function
A.14.1 Position of Document
The Bookeye
®
4 scanner offers a helpful function which detects fingers at the margin of
books and eliminates them from the image. This is the “Finger Removal” function.
The following easy-to-understand requirements must be fulfilled to operate the
Bookeye
®
4 using the “Finger Removal” function properly:
• The book cradle can be set to “V” position or in flat position.
• Place the book as shown in Picture 19 or Picture 20 on the book cradle. Let a
small distance between the book’s bottom side and the lower margin of the book
cradle.
Please note: The following pictures show an earlier version of the Bookeye 4-V2 scanner housing.
Picture 20: Book at book cradle in flat position
Picture 21: Book at book cradle opened in “V” position
• The distance depends on the thickness of the book. The distance should be at
least the half of the thickness of the book.
• The book must be aligned parallel to the horizontal red laser line.
• The book fold area must be placed below the vertical red laser line.
To Next Page
Loading...
Need help?
General
