Manual Page 17
A.6 Device Location
Please allow a minimum of 150 mm (6 inch) from any side walls and 300 mm (12 inch)
from a back wall. Leave one meter (3 feet) minimum distance from any door or entrance
way. Use illustration below as a guide.
Picture 1: Minimum distances to the scanner
Do not operate the scanner in an area that has poor air circulation, and/or that is non-
ventilated.
Place the WideTEK 36 on a flat and solid base. The load bearing capacity of the base
must correspond to the device weight.
It is recommended to place the WideTEK 36 always on the floor stand which comes with
the scanner. The floor stand gives the best ergonomic position when using the scanner.
Choose a location that complies with the limits of temperature and humidity. Refer to the
technical specification.
Note: Before using the WideTEK 36 scanner in the new environment allow at least one
hour for temperature adaptation.
Temperature adaptation means:
A fast change from cold to warm environmental conditions can build up
condensation inside the housing. This will result in unfavorable scanned images
and could cause permanent damages to the unit.
To Next Page
Loading...
Need help?
General
