Page 18 Manual
A.7 Maintenance
Important: Ensure that no liquids will penetrate into the device housing.
A.7.1 Touchscreen
Before cleaning the touchscreen, switch the WideTEK 36 off and set the main power
switch to position 0.
The touchscreen can be cleaned with a micro fiber cloth.
A.7.2 Surfaces
Use a soft, dampened cloth to clean the housing of the scanner. Recommended is a micro
fiber cloth.
A.7.3 Glass plate
Important: Do not use any cleanser with solvents to clean the glass plate!
The glass plate of the WideTEK 36 has a special surface coating.
It is recommended to clean the glass plate always with a micro fiber cloth.
Dampen the micro fiber cloth slightly before cleaning.
Clean the glass plate with minimum pressure. Do not rub the glass plate on isolated
positions.
After cleaning dry the glass plate with a soft cloth.
A.8 Repair
Note: There are not any parts or components of the WideTEK 36 scanner which can
be repaired by the user.
All repairs and service works should be done by a trained technician only.
To Next Page
Loading...
Need help?
General
