Manual Page 35
A.17.2 White Balance
Note: The paper transport wings must be inserted before starting the white balance.
Picture 30: Insert control sheet
Touch the White Balance button to start the
white balance measurement sequence. Now
insert the control sheet. It must be transported
forward and reverse. Then touch the Cont.
button.
The control sheet will be pulled in and the
measurement starts. While the measurement is
running a graphic symbol shows the progress.
The Abort button returns to the previous screen.
Picture 31: Results of White Balance
After the white balance has been finished, the
result is displayed.
Touch the Finish button to return to the
Self Test 1 screen.
A.17.3 Lamp On / Off
Touch the Lamp On / Off button to switch the lamps on. As long as the button is touched,
the lamps will shine.
A.17.4 Exit Selftest
Touching Exit Selftest finalizes the setup mode, switches to the operation mode and
shows the start menu.
To Next Page
Loading...
Need help?
General
