15
XP7202 Instruction Manual
Selecting a Channel
NOTE: Before operation, it is necessary to select the
desired channel.
Section 5: Quick Start
To Select a Channel (Transmitter)
Press and hold the Down and Select key
simultaneously while turning on the transmitter to enter
system set up mode.
Press the UP or Down key until SYNTHESIZED CH
appears on screen.
Press the IncreaSe or DecreaSe key to select the
desired channel.
Press the Down and Select keys simultaneously to
return to the WARNING screen.
To transmit on the selected channel displayed in the
warning screen, press the clear key. The screen will
change to the main screen and the transmitter will emit a
signal on the selected channel.
NOTE
: When turning on the transmitter, the
warning screen is displayed with the previously
selected channel. No signal is being transmitted.
To accept this displayed channel, press the
clear key. A signal will then be transmitted on
the selected channel.
To Next Page
Loading...
Need help?
General
