2600AS-901-01 Rev. B / September 2008 Return to Section Topics 12-13
Series 2600A System SourceMeter® Instruments Reference Manual Section 12: TSP Fundamentals and Script Management
Loading scripts from the USB flash drive
You can use the LOAD feature to load a script from the USB flash drive to the run time
environment. The Series 2600A validates the script before the load is completed. You can view the
errors on the front panel of the Series 2600A.
Once a script is loaded from the USB flash drive, you can associate the script with the front panel's
RUN button or save the script to internal nonvolatile memory.
ACTIVE-FOR-RUN: If this option is selected, the script can be executed by pressing the front
panel's RUN button.
SAVE-INTERNAL: If this option is selected, the script is saved to internal nonvolatile memory.
To load a script from the USB flash drive:
1. Press MENU > SCRIPT and then choose LOAD.
2. Choose USB1.
3. Turn the navigation wheel left or right to view the files on the USB flash drive.
4. Select the desired file by highlighting it and pressing ENTER or the navigation wheel.
5. Choose one of the following:
• (Save only) SAVE-INTERNAL
•Select YES.
• (Run only) ACTIVE-FOR-RUN.
•Select YES.
6. If you chose ACTIVE-FOR-RUN, execute the script by pressing EXIT and then RUN.
Working with subdirectories from the front panel
To access subdirectories while in local mode:
1. From the front panel, press MENU > SCRIPT > LOAD > USB1.
2. Turn the navigation wheel left or right to select the desired directory. The files in the
subdirectory are displayed.
Figure 12-5
Subdirectories
To Next Page
Loading...
Need help?
General
