Keithley 2611B Reference Manual

Series 260
0B System SourceMeter® Instrument Reference Manual Section 7:
TSP command reference
2600BS-901-01 Rev. B / May 2013 7-121
lan.reset()
This function resets the LAN interface.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands lan.restoredefaults() and
lan.applysettings().
Also see
lan.applysettings() (on page 7-111)
lan.restoredefaults() (on page 7-121)
lan.restoredefaults()
This function resets LAN settings to default values.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
lan.restoredefaults()
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute Default setting
lan.autoconnect
lan.ENABLE
lan.config.dns.address[N]
"0.0.0.0"
lan.config.dns.domain
""
lan.config.dns.dynamic
lan.ENABLE
lan.config.dns.hostname
""
lan.config.dns.verify
lan.ENABLE
lan.config.duplex
lan.FULL
lan.config.gateway
"0.0.0.0"
lan.config.ipaddress
"0.0.0.0"
lan.config.method
lan.AUTO
lan.config.speed
100
lan.config.subnetmask
"255.255.255.0"
lan.linktimeout
20
(seconds)
lan.lxidomain
0
lan.nagle
lan.ENABLE
lan.timedwait
20 (seconds)
This command is run when lan.reset() is sent.

Keithley 2611B Specifications

General

Brand	Keithley
Model	2611B
Category	Measuring Instruments
Language	English