System SourceMeter® Instrument Reference Manual Section 7:
2600BS-901-01 Rev. B / May 2013 7-215
Also see
smuX.measure.autorangeY (on page 7-198)
smuX.measure.Y() (on page 7-213)
smuX.source.autorangeY (on page 7-217)
smuX.trigger.source.limitY (on page 7-247)
smuX.trigger.source.linearY() (on page 7-248)
smuX.trigger.source.listY() (on page 7-249)
smuX.trigger.source.logY() (on page 7-250)
Sweep Operation (on page 3-20)
smuX.nvbufferY
This attribute contains a dedicated reading buffer.
Type TSP-Link accessible Affected by Where saved Default value
Usage
bufferVar = smuX.nvbufferY
The dedicated reading buffer
Source-measure unit (SMU) channel (for example, smua.nvbuffer1 applies to
SMU channel A)
SMU nonvolatile buffer (1 or 2)
Details
Each SMU channel contains two dedicated reading buffers: smuX.nvbuffer1 and smuX.nvbuffer2.
All routines that return measurements can also store them in either reading buffer. Overlapped measurements
are always stored in a reading buffer. Synchronous measurements return either a single-point measurement or
can be stored in a reading buffer if passed to the measurement command.
The dedicated reading buffers can be saved to internal nonvolatile memory (to retain data between power
cycles) using the smuX.savebuffer() function.
Example
smua.measure.overlappedv(smua.nvbuffer1)
Store voltage readings from SMU channel A
into SMU channel A dedicated reading
Also see
Configuring and running sweeps (on page 3-29)
Reading buffers (on page 3-6)
savebuffer() (on page 7-161)
smuX.makebuffer() (on page 7-197)
smuX.measure.overlappedY() (on page 7-209)
smuX.savebuffer() (on page 7-216)
smuX.trigger.measure.action (on page 7-241)
smuX.trigger.measure.set() (on page 7-241)
smuX.trigger.measure.stimulus (on page 7-242)
smuX.trigger.measure.Y() (on page 7-244)
To Next Page
Loading...
Need help?
General
