To Next Page

To Previous Page

Series 2600B

System SourceMeter® Instrument Reference Manual Section 7:

TSP command reference

2600BS-901-01 Rev. B / May 2013 7-179

Example

settimezone("8", "1", "3.3.0/02", "11.2.0/02")

settimezone(offset)

Sets offset to equal +8 hours, +1

hour for DST, starts on Mar 14 at 2:00

a.m, ends on Nov 7 at 2:00 a.m.

Sets local time zone to offset.

Also see

gettimezone() (on page 7-98)

os.time() (on page 7-151)

settime() (on page 7-177)

setup.poweron

This attribute specifies which saved setup to recall when the instrument is turned on.

Type TSP-Link accessible Affected by Where saved Default value

Attribute (RW)

Yes

Not applicable

Nonvolatile memory

Usage

id = setup.poweron

setup.poweron = id

An integer that specifies the setup to recall when the instrument power is

turned on (0 to 5)

Details

When id = 0, the instrument uses the factory default setup when it is turned on. When id is set to 1 to 5, it uses

the setup saved with setup.save().

Only setups stored in nonvolatile memory are available (you cannot recall a script from a USB flash drive with

this command).

Example

setup.poweron = 0

Set the instrument to use the factory default setup

when power is turned on.

Also see

setup.save() (on page 7-181)

Start-up (power-on) configuration (on page 2-48)

Keithley 2611B Reference Manual

Other manuals for Keithley 2611B