Keithley 3720-ST User Manual

Section 9: Introduction to TSP operation Series 3700A System Switch/Multimeter Reference Manual
9-30 3700AS-901-01 Rev. D/June 2018
Local node
Commands that allow you to set and read from the local node.
localnode.define.* (on page 11-283)
localnode.description (on page 11-284)
localnode.linefreq (on page 11-285)
localnode.model (on page 11-286)
localnode.password (on page 11-286)
localnode.passwordmode (on page 11-287)
localnode.prompts (on page 11-288)
localnode.prompts4882 (on page 11-289)
localnode.reset() (on page 11-289)
localnode.revision (on page 11-290)
localnode.serialno (on page 11-291)
localnode.showerrors (on page 11-291)
node[N].execute() (on page 11-295)
node[N].getglobal() (on page 11-296)
node[N].setglobal() (on page 11-296)
settime() (on page 11-352)
PTP
Use these functions and attributes to configure the IEEE Std 1588 Precision Time Protocol (PTP).
IEEE-1588 allows multiple devices to synchronize time to a less than 10 ms accuracy. Further
information on the protocol, operation, and terminology is available from the IEEE organization
documentation and other third-party sources.
The Series 3700A commands support the 2008 IEEE-1588 standards, as indicated below.
ptp.domain (on page 11-303)
ptp.ds.info (on page 11-303)
ptp.enable (on page 11-305)
ptp.portstate (on page 11-305)
ptp.slavepreferred (on page 11-306)
ptp.time() (on page 11-307)
ptp.utcoffset (on page 11-307)

Keithley 3720-ST Specifications

General

Brand	Keithley
Model	3720-ST
Category	Multimeter
Language	English