Keithley 3720-ST User Manual

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-286 3700AS-901-01 Rev. D/June 2018
localnode.model
This attribute stores the model number.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
model = localnode.model
model
The model number of the instrument
Example
print(localnode.model)
Outputs the model number of the local node. For example:
3700A
Also see
localnode.serialno (on page 11-291)
localnode.password
This attribute stores the remote access password.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (W)
Yes
LAN reset
Nonvolatile memory
"admin"
Usage
localnode.password = "password"
passWord
A string that contains the remote interface password
Details
This write-only attribute stores the password that is set for any remote interface. When password
usage is enabled (localnode.passwordmode), you must supply a password to change the
configuration or to control an instrument from a web page or other remote command interface.
The instrument continues to use the old password for all interactions until the command to change it
executes. When changing the password, give the instrument time to execute the command before
attempting to use the new password.
You can retrieve the password from the front panel through MENU > LAN > STATUS > PASSWORD.
You can reset the password by resetting the LAN from the front panel or by using the lan.reset()
command.
When using this command from a remote node, localnode should be replaced with the node
reference, for example, node[5].password.

Keithley 3720-ST Specifications

General

Brand	Keithley
Model	3720-ST
Category	Multimeter
Language	English