Keithley 3720-ST User Manual

Series 3700A System Switch/Multimeter Reference Manual Section 11: TSP command reference
3700AS-901-01 Rev. D/June 2018 11-409
trigger.blender[N].stimulus[M]
This attribute specifies the events that trigger the blender.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Reset
Recall setup
Trigger blender N reset
Create configuration script
Save setup
0
Usage
eventID = trigger.blender[N].stimulus[M]
trigger.blender[N].stimulus[M] = eventID
eventID
The event that triggers the blender action; see Details
N
An integer representing the trigger event blender (up to two)
M
An integer representing the stimulus index (1 to 4)
Details
There are four acceptors that can each select a different event. The eventID parameter can be the
event ID of any trigger event.
The eventID parameter may be one of the existing trigger event IDs shown in the following table.
Trigger event ID
Description
channel.trigger[N].EVENT_ID
A channel trigger event starts the scan.
digio.trigger[N].EVENT_ID
An edge (either rising, falling, or either based on the
configuration of the line) on the digital input line.
display.trigger.EVENT_ID
The trigger key on the front panel is pressed.
dmm.trigger.EVENT_LIMIT1_HIGH
A DMM trigger event that indicates a measurement has exceed
the high limit value on limit 1.
dmm.trigger.EVENT_LIMIT1_LOW
A DMM trigger event that indicates a measurement has exceed
the low limit value on limit 1.
dmm.trigger.EVENT_LIMIT2_HIGH
A DMM trigger event that indicates a measurement has exceed
the high limit value on limit 2.
dmm.trigger.EVENT_LIMIT2_LOW
A DMM trigger event that indicates a measurement has exceed
the low limit value on limit 2.
trigger.EVENT_ID
A *trg message on the active command interface. If GPIB is the
active command interface, a GET message also generates this
event.
trigger.blender[N].EVENT_ID
A combination of events has occurred.
trigger.timer[N].EVENT_ID
A delay expired.
tsplink.trigger[N].EVENT_ID
An edge (either rising, falling, or either based on the
configuration of the line) on the TSP-Link trigger line.
lan.trigger[N].EVENT_ID
A LAN trigger event has occurred.
scan.trigger.EVENT_SCAN_READY
Scan ready event.
scan.trigger.EVENT_SCAN_START
Scan start event.
scan.trigger.EVENT_CHANNEL_READY
Channel ready event.
scan.trigger.EVENT_MEASURE_COMP
Measure complete event.
scan.trigger.EVENT_SEQUENCE_COMP
Sequence complete event.
scan.trigger.EVENT_SCAN_COMP
Scan complete event.
scan.trigger.EVENT_IDLE
Idle event.
schedule.alarm[N].EVENT_ID
A scan starts when alarm N fires.

Keithley 3720-ST Specifications

General

Brand	Keithley
Model	3720-ST
Category	Multimeter
Language	English