Keithley 3720-ST User Manual

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-182 3700AS-901-01 Rev. D/June 2018
Also see
dmm.close() (on page 11-160)
dmm.configure.recall() (on page 11-165)
dmm.configure.set() (on page 11-166)
dmm.setconfig() (on page 11-227)
scan.add() (on page 11-309)
scan.create() (on page 11-315)
dmm.inputdivider
This attribute determines when the 10 MΩ input divider is enabled.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
Instrument reset
DMM reset
Recall setup
Create configuration script
Save setup
0 (dmm.OFF)
Usage
state = dmm.inputdivider
dmm.inputdivider = state
state
Disable input divider: dmm.OFF or 0
Enable input divider: dmm.ON or 1
Details
This attribute is only valid when dmm.func is set to DC volts.
The input divider setting is saved with the dmm.func function setting, so if you use another function,
then return to "dcvolts", the input divider setting you set previously is retained.
An error is generated if you try to set input divider for any DMM function other than "dcvolts". Error
code 1114, "Setting conflicts with function selected," is generated. If you query any DMM function
other than "dcvolts" for input divider, nil is returned with the same error.
Example
dmm.func = "dcvolts"
dmm.inputdivider = dmm.ON
Enables the input divider for DC volts.
Also see
DC volts input divider (on page 4-62)
dmm.configure.recall() (on page 11-165)
dmm.configure.set() (on page 11-166)
dmm.func (on page 11-179)

Keithley 3720-ST Specifications

General

Brand	Keithley
Model	3720-ST
Category	Multimeter
Language	English